Light treatment unit is used for the principle of radiological radiation to solidify the light-sensitive resin by pulling on it in a short time, it is used to restore teeth and solidify the material for whitening teeth.
P1 High Intensity Mode
Cure Time For orthodontic brackets, posts and cores and porcelain veneer light-curing adhesive.
High intensity mode
Constant intensity: 2300-2500mw/cm Used for rapid curing, ensuring sufficient curing depth, more efficient
Time setting: 1s. 3 sec

P2 General intensity mode
Curing time For normal resin.
General Mode Constant Intensity: 1000-1200mw/cm for most treatment scenarios like tooth filling, restoration, etc.
Time setting: 5s, 10s. 15s, 20s

.Super large battery capacity
2600mAh Lithiurn Battery – CB International Certification
MaxCure9 battery capacity is 85% higher than normal curing lights

constant current driver
Constant light intensity. Constant light intensity output, stabilizing working power

Automatic light guide detection
The main unit will detect the light guide and stop flashing “Er” if the guide is connected well, or the main unit will close after 10 seconds of flashing.

Overheat protection

The main unit will detect the temperature. The overheating protection program will run when the curing light reaches a certain temperature after long time use. It continues to flash until 200s later it recovers from the high temperature.